Grizzly H0603 Cutting Depth Adjustment, Fine Tuning Angle of Blade, Remove battery

Page 14

SAW OPERATIONS, CON’T

Cutting Depth Adjustment:

1.Remove battery.

2.Loosen the black knob to the left and below the hand grip.

3.Pull or push the saw base to expose more or less saw blade.

4.To check the depth of cut compare the blade depth to the workpiece thickness and adjust saw base until one half of one tip of a tooth is exposed past the workpiece. Refer to Figure 7 & 8.

5.Tighten the black lock knob.

Adjust saw base so that only one-half of a tip of one tooth on the blade is exposed past the thickness of the work- piece to help avoid potential kick-back .

Fine Tuning Angle of Blade:

1.Remove battery.

2.Adjust the depth of cut so that all of the blade is exposed below the saw base.

3.Loosen the black knob located on the leading edge of the saw.

4.Rotate the saw so the exposed por- tion of the blade is up. Place a small square on the base and butt it up against the blade. Take care that the square does not come into contact

Fig 7. Depth of cut adjusted correctly.

with any carbide teeth.

5.Adjust the base so that the edge of the square contacts the the full face of the exposed part of the blade.

6.Tighten the angle locking knob.

50

40

30

20

10

90° Stop

Fig 8. Base angle adjustment.

Operating this equipment has the potential to propel debris into the air which can cause eye injury. Always wear safety glasses or goggles when operating equip- ment. Be certain the safety glasses you wear meet the appropriate standards of the American National Standards Institute (ANSI).

-12-

H0603 18V Cordless Drill and Saw

Image 14
Contents 18V Cordless Drill and SAW Model H0603H0603 18V Cordless Drill and Saw Safety Before Operating This EquipmentAMP Length Rating 100ftAdditional Safety Battery Must be Recycled or DisposedIntroduction CommentaryGetting Started Inserting Battery Into DrillDrill Operations Inserting and Removing Bits and DriversDrill OPERATIONS, CON’T Operating the drill Operating Guides and Tips Drill MaintenanceMaintenance Disposed of properly. Refer to the GrizzlySAW Operations From FigureSAW OPERATIONS, CON’T From Figure Blade Retaining Screw Secures bladeRemoving and Installing Blades Remove the BatteryRemove battery Cutting Depth AdjustmentFine Tuning Angle of Blade Guide Notch and Scale Setting the Edge GuideSetting Blade Angle Serious personal injury Inserting Battery Into Trim SawPotential for injury using this Ing cutSAW Maintenance Match your feed rate to the materialWarranty and Returns H0603 18V Cordless Drill and Saw H0603 18V Cordless Drill and Saw Warranty Card Grizzly INDUSTRIAL, INC