DRILL OPERATIONS, CON’T
2.Hold the chuck by the collar while turning the sleeve (the forward sec- tion). See Figure 1. This will cause the three chuck jaws located inside the recess to open or close depend- ing upon the direction.
3.When the jaws are at the approximate diameter of the bit or driver, insert the shank end of the bit or driver into the jaw opening.
4.Turn the sleeve clockwise until it tight- ens around the bit or driver. Never “power tighten” which is holding the sleeve while running the drill. This can cause a loose grip on the bit or driver and potential damage to chuck jaws. Check for tightness periodically while using the tool.
5.To release the bit or driver, hold the chuck collar, and turn the sleeve counterclockwise.
Fig 1. Inserting bits into the chuck.
Operating this equipment has the potential for flying debris to cause eye injury. Always wear safety glasses or goggles when operating equipment. Everyday glasses or reading glasses only have impact resistant lenses, they are not safety glasses. Be certain the safety glasses you wear meet the appropriate standards of the American National Standards Institute (ANSI).
Like all power tools, there is danger associated with the Model H0603. Accidents are frequently caused by lack of familiarity or failure to pay attention. Use this tool with respect and caution to lessen the possibility of operator injury. If normal safety pre- cautions are overlooked or ignored, serious personal injury may occur.
H0603 18V Cordless Drill and Saw |