3. ;Vb^a^Vg^oZndjghZa[l^i]i]ZWaVYZ\j^YZXdc" | |
igdahh]dlc^cFigure 45# |
|
7aVYZ | AViZgVa |
<j^YZ | 6Y_jhibZci |
7ZVg^c\h | GdY8Ve |
| HXgZl |
@cjgaZY | 7ZVg^c\GdiVi^dc |
6Y_jhibZci8Ve | |
@cdW | HXgZl |
Figure 45.7aVYZ\j^YZXdcigdah# |
4. AddhZc i]Z XVe hXgZl dc i]Z aViZgVa VY_jhi"
bZci gdY VcY VY_jhi i]Z WaVYZ \j^YZh jci^a
i]ZZY\Zhd[i]ZWZVg^c\hVgZ&$&+WZ]^cYi]Z
WaVYZ\jaaZihVh^aajhigViZY^cFigure 46#
Note: The 1/16" spacing is ideal, although with larger blades it may not be possible. In such cases, adjust the guide bearings as far for- ward as possible to the blade gullets, and still maintain the proper support bearing spacing adjustment.
7aVYZ |
<jaaZi |
Figure 46.AViZgVaVY_jhibZcid[WaVYZ\j^YZh# |
<%*&)M"M(B[\#&%$%* !<%*&)M'B[\#)$%,
NOTICE
Make sure that the blade teeth will not con- tact the guide bearings when the blade is against the rear support bearing during the cut or the blade teeth will be ruined.
5. I^\]iZci]ZXVehXgZldci]ZaViZgVaVY_jhi" bZcigdY#
6. AddhZc i]Z WZVg^c\ gdiVi^dc VY_jhibZci XVe hXgZlh#
7. GdiViZ i]Z `cjgaZY `cdW id edh^i^dc i]Z WZVg^c\h%#%%)VlVn[gdbi]ZWaVYZ#Note: 0.004" is approximately the thickness of a dollar bill.
8. I^\]iZci]ZXVehXgZlidadX`i]ZWaVYZ\j^YZ WZVg^c\h^cedh^i^dc#
9. GZeZVii]^hegdXZYjgZ[dgi]ZadlZg\j^YZh#
NOTICE
Whenever changing a blade or adjusting ten- sion and tracking, the upper and lower blade support bearings and guide bearings must be properly adjusted before cutting opera- tions.
"(("