TROUBLESHOOTING
Problem |
| Possible Cause |
| Possible Solution |
Engine will not start. | 1. | Low or no fuel in fuel tank or | 1. | Fill fuel tank with proper 25:1 unleaded |
|
| improper |
| |
| 2. | Not enough fuel getting to | 2. | Press primer |
|
| carburetor. |
| “START”. Then attempt to start engine. |
| 3. | Faulty spark plug. | 3. | Clean or replace spark plug. |
| 4. | Contaminated fuel. | 4. | Have a qualified service technician |
| 5. | Insufficient electrical current |
| empty old fuel from fuel tank. Then, refill |
|
| getting to spark plug. |
| fuel tank with fresh fuel mixture. |
|
|
| 5. | Have a qualified service technician |
|
|
|
| inspect electrical system. |
Engine runs, but auger | 1. | Speed control not properly | 1. | Make sure to fully squeeze the speed |
not rotating. |
| used. |
| control. |
| 2. | Speed control cable not | 2. | Have a qualified service technician |
|
| properly adjusted. |
| adjust speed control cable. |
| 3. | Auger stuck in rocks, roots, | 3. | Remove auger from hole and clear hole |
|
| etc. |
| of obstructions. |
Auger rotates while | Engine idle speed set too high. | Have a qualified service technician reset | ||
engine is at idle. |
|
| carburetor idle adjustment screw to lower | |
|
|
| idle (RPM) speed. | |
Gearbox feels | Low gear oil. | Immediately turn off Auger Drill. Allow | ||
exceptionally hot to the |
|
| gearbox to completely cool. Then, fill | |
touch. |
|
| gearbox with SAE | |
Kill switch does not turn | Faulty kill switch. | Immediately remove spark plug cap from | ||
off engine. |
|
| spark plug to stop engine. Discontinue | |
|
|
| using Auger Drill until the tool is repaired by | |
|
|
| a qualified service technician. | |
PLEASE READ THE FOLLOWING CAREFULLY
The manufacturer and/or distributor has provided the parts list and assem- bly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states that all repairs and parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liability arising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts.
REV 07e
SKU 95346 | For technical questions, please call | PAGE 13 |