10.CAUTION: Some woods contain preservatives such as copper chromium arsenate (CCA) which can be toxic. When drilling these materials extra care should be taken to avoid inhalation and minimize skin contact.
11.ALLOW THE DRILL BIT TO SPIN UP TO FULL SPEED BEFORE DRILLING INTO THE WORKPIECE. When turning off the Drill Press, allow the drill bit to spin down and stop on its own. Do not press the drill bit against the workpiece to stop it.
12.DO NOT FORCE THE DRILL BIT INTO THE WORKPIECE WHEN DRILLING. Apply moderate downward pressure, allowing the drill bit to cut without being forced.
13.NEVER ATTEMPT TO REMOVE MATERIAL STUCK IN THE MOVING PARTS OF THE DRILL PRESS WHILE THE DRILL PRESS IS PLUGGED IN AND RUNNING.
14.THE DRILL BIT WILL BECOME HOT WHILE DRILLING. Allow the drill bit to completely cool before touching.
15.WHENEVER POSSIBLE, USE CLAMPS OR OTHER SAFE, PRACTICAL WAYS TO HOLD AND SUPPORT THE WORKPIECE. Do not attempt to drill material that does not have a flat surface, unless a suitable support is used.
16.ALWAYS DISCONNECT THE DRILL PRESS FROM ITS ELECTRICAL SUPPLY SOURCE BEFORE PERFORMING ANY SERVICES OR MAINTENANCE such as leaving the work area, moving the tool from one location to another, changing the drill bit, cleaning sawdust from the unit, etcetera.
UNPACKING
When unpacking, check to make sure all parts shown on the Parts Lists (pages 13 through 16) are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to pages 13 through 16 of this manual.
To Assemble The Drill Press:
1.To attach the Column Support (part #3A) to the Base (part #4A), use the four Hex Head Screws (part #5A) provided. (See Assembly Diagram A.)
2.To attach the Table (part #9A) to the Drill Press, insert the collar of the Table (located on the underneath) into the Table Support (part #10A). Then, lock the Table in place, using the Hex Head Screw (part 8A) and the Hex Head Socket Screw
(part 17A). (See Assembly Diagram A.)
SKU 44836 | PAGE 5 |