Harbor Freight Tools 38142 manual Mounting, Assembly, Specifications, Setup Before Use

Specifications

SAFETY

Motor Power	3/4 HP - 16 speeds ranging from 220 to 3600 RPM
Electrical Rating	120V~, 60Hz, 7.5A, Single-Phase
Drill Chuck Capacity	7/64″ to 5/8″
Spindle Stroke	3-1/8″
Swing	13-1/4″
Column Diameter	2- 57/64″
Dry Table	11-1/2″ Diameter
Table Slot	1/2″
Overall Height	41-3/4″
Weight	110 lbs.
Product Use	For heavy-duty use on metal, plastic or wood materials.
	Table rotates 360º and tilts 0-45º in 1º increments.

SETUP

OPERATION

MAINTENANCE

Setup - Before Use:

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before performing any procedure in this section.

Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.

Mounting

Secure the tool to a supporting structure before use.	Verify that installation surface has no hidden
Before assembly, bolt the Base to a flat, level,	utility lines before drilling or driving screws.
solid workbench capable of supporting the
weight of the drill press and any workpieces.

Assembly

Column Assembly to Base

1.	With the Base (6B) on a flat level surface,	3. Insert the Column (1B) into its Support (4B) and
	bolt on the Column Support (4B) using the	firmly secure with the Hex socket set screws (3B).
	four M10x40mm Hex Head screws (5B).	Note: It may be necessary to screw out the set
2.	Tighten firmly.	screws beforehand, as they may protrude into the
		tube preventing the column from sliding in fully.

Page 6 For technical questions, please call 1-800-444-3353. Item 38142