Harbor Freight Tools 38142 manual Functions, Installing the Drive Belts

Page 8

Installing the Drive Belts

SAFETY

1.Undo the Belt Tension Locking Knobs (18A) on both sides of the head. Turn the Belt Tension Lever (19A) clockwise to bring the Motor Pulley (11A) close to the Spindle Pulley allowing the belts to be slipped on with ease.

2.Lubricate the Idler Pivot Shaft (20) and

Idler Pulley (19), with light grease, and install in its mounting between the motor and spindle pulleys.

3.Consult the chart inside the pulley cover

(or the Drill Speed chart in this manual), and install the belts in the positions corresponding to spindle/drill speed required.

4.Turn the Belt Tension Lever (19A) counterclockwise so that tension is applied to the belts (see Head Assembly diagram). Tension is correct when the belts deflect by approximately 1/2″ at their centers of run when using reasonable thumb pressure. Lock the motor in this position with the locking knob.

SETUP

OPERATION

MAINTENANCE

Functions

Page 8

For technical questions, please call 1-800-444-3353.

Item 38142

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Page Table of Contents General Tool Safety WarningsSafety Setup Operation Maintenance Grounding Instructions Drill Press Safety Warnings110-120 V~ Grounded Tools Tools with Three Prong Plugs Vibration Safety Assembly SpecificationsSetup Before Use Column Assembly to BaseInstalling the Chuck Table and Support Arm to ColumnHead to Column Pulley Cover KnobInstalling the Drive Belts FunctionsTool Set Up Table AdjustmentSetting a Drilling Depth Operating InstructionsBit Installation Changing Drill SpeedWorkpiece and Work Area Set Up General Operating InstructionsBelt Inspection and Tensioning Cleaning, Maintenance, and LubricationMaintenance and Servicing Troubleshooting Problem Possible Causes Likely SolutionsPulley and Spindle Parts List and Diagram Parts Lists and DiagramsParts List and Diagram a Head Parts List and Diagram B Base and Table Limited 90 Day Warranty
Top Page Image Contents