Harbor Freight Tools 44849 manual To Insert And Remove Drill Bits And Drivers, Figure D

Page 7

To Insert And Remove Drill Bits And Drivers:

REVERSING SWITCH

TRIGGER

BATTERY

FIGURE D

1.Set the Reversing Switch (16) to the “LOCKED” (Center) position. (See Figure D.)

2.Hold the Chuck firmly while turning the forward section of the Chuck counterclockwise. This opens the Chuck to accept the drill bit. Insert the drill bit into the chuck fully.

3.Turn the forward section of the Chuck clockwise while holding the Chuck firmly in place to tighten the Chuck around the drill bit shaft. Make sure the drill bit is seated securely before operation.

4.To remove the drill bit, repeat Steps 1 and 2.

Note: A Magnetic Driver Bit Adapter is provided for use with the supplied driver bits. First, insert the driver bit into the end of the Driver Bit Adapter. Then, insert the Hex end of the Driver Bit Adapter in the Chuck as you would do with a drill bit.

5.The Cordless Drill is ready for use.

REV 03a; 08a

SKU 44849

For technical questions, please call 1-800-444-3353.

Page 7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Distributed exclusively by Harbor Freight Tools For technical questions or replacement parts, please callGeneral Safety Warnings and Precautions SpecificationsFor technical questions, please call Specific Product Warnings and Precautions For technical questions, please call Unpacking To Charge The BatterySee Figure C To Attach The Charged Battery To The DrillFigure D To Insert And Remove Drill Bits And DriversOperating Instructions To Operate The Reversing SwitchTo Operate The Torque Selector Drilling An Object Drill Bit SelectionDisposal of Ni-Cd Battery Cleaning and MaintenancePart Description Parts ListSKU For technical questions, please call Parts Assembly Electrical Schematic Limited 90 DAY Warranty
Top Page Image Contents