Chicago Electric 46804 operating instructions Tool USE and Care

Page 4

12.Avoid accidental starting. Be sure the Power Switch is off before plugging in. Carrying power tools with your finger on the Trigger invites accidents.

13.Remove adjusting keys or wrenches before turning the power tool on. A wrench or a key that is left attached to a rotating part of the power tool may result in personal injury.

14.Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the power tool in unexpected situations.

15.Use safety equipment. Always wear ANSI approved eye protection. Dust mask, non-skid safety shoes, hard hat, or hearing protection must be used for appropriate conditions.

TOOL USE AND CARE

16.Use clamps (not included) or other practical ways to secure and support the workpiece to a stable platform. Holding the work by hand or against your body is unstable and may lead to loss of control.

17.Do not force the tool. Use the correct tool for your application. The correct tool will do the job better and safer at the rate for which it is designed.

18.Do not use the power tool if the Trigger does not turn it on or off. Any tool that cannot be controlled with the Power Switch is dangerous and must be re- placed.

19.Disconnect the Power Cord Plug from the power source before making any adjustments, changing accessories, or storing the tool. Such preventive safety measures reduce the risk of starting the tool accidentally.

20.Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the hands of untrained users.

21.Maintain tools with care. Keep cutting tools sharp and clean. Properly maintained tools with a sharp cutting bits are less likely to bind and are easier to control. Do not use a damaged tool. Tag damaged tools “Do not use” until repaired.

22.Check for misalignment or binding of moving parts, breakage of parts, and any other condition that may affect the tool’s operation. If damaged, have the tool serviced before using. Many accidents are caused by poorly main- tained tools.

SKU 46804 For technical questions, please call 1-800-444-3353.

Page 4

Image 4
Contents For technical questions and replacement parts, please call Single SPEED, Electric DrillProduct Specifications General Safety RulesSave this Manual Work AreaElectrical Safety Personal SafetyTool USE and Care Specific Safety Rules ServicePage Grounding Grounded Tools Tools with Three Prong PlugsExtension Cords Double Insulated Tools Tools with TWO Prong PlugsSee Figure C, next See Figure CSymbology Extension Cord LengthUnpacking Operating InstructionsTo Install Bits See on page ten and below Operating InstructionsPlastic and plastic coated chipboard INSPECTION, MAINTENANCE, and Cleaning Parts List Please Read the Following CarefullyAssembly Diagram