Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
The Hammer Drill is equipped with a keyed Chuck (2). Follow these steps to insert a bit.
1.Insert the Chuck Key (3) into the Chuck (2) and turn counterclockwise to open the mouth of the Chuck.
2.Insert the hammer bit or the drill bit (not supplied) all the way into the Chuck.
3.Turn the Chuck Key clockwise to tighten the Chuck on the bit.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to al- low free movement while working.
3.Secure loose work pieces using a vise or clamps (not included) to pre- vent movement while working.
4.There must not be hazardous ob- jects, such as utility lines or foreign objects, nearby that will present a hazard while working.
General Operating Instructions
1.Plug the Line Cord into an electrical outlet.
Switch On
Locking
Button
Forward/Reverse Switch
Variable Speed Knob 
Trigger Switch (24)
Figure E
2.Press the Forward/Reverse Switch to correct position for the current job. See Figure E.
Right position: drill or fasten (clock- wise).
Left position: removing fasteners or freeing bits (counterclockwise).
3.Adjust the Variable Speed Knob for the desired (maximum) speed action when the Switch is pressed.
4.For precision depth drilling, loosen the Wing Nut securing the Auxiliary Handle (501), and slide the Depth Gauge (502) down, gauging the depth from the bit tip. Retighten the Wing Nut again.
5.Verify that the bit is securely locked in the Chuck (2).
SKU 45338 | For technical questions, please call | Page 10 |