Gear Setting 
Control
Figure F (top view)
6.On the top of the Hammer Drill, push the Gear Setting Control to select plain drilling or hammer drilling.
A symbol for a drill bit indicates plain drilling is selected. If a hammer is shown, it is set for hammer drilling. See Figure F.
Note: While using the Hammer Drill, al- ways use both hands.
7.Press (and hold) the trigger Switch (24) to turn the drill on.
This Switch varies the speed depend- ing on how far in it is pressed.
8.Optionally, after pressing in the trig- ger Switch, you can press the Switch
On Locking Button to keep the drill running without keeping your finger on the trigger Switch (24).
Use this function when drilling soft materials only. Press the trigger Switch again to turn it off.
CAUTION! Do not drill or hammer hard, brittle materials such as steel or concrete with the Switch On Locking Button pressed in (ON). If the drill bit catches on the material, the high torque of the drill will cause the tool body to twist around without stopping. This violent action could cause injury to your hands and arms. It could also damage the Hammer Drill.
9.To prevent accidents, turn off the tool and disconnect its power supply after use. Clean, then store the tool in- doors out of children’s reach.
SKU 45338 | For technical questions, please call | Page 11 |