Henny Penny BCF-24/65/110 Condensation, Bend out the clips securing the rodent cover on the back

Page 7

	Model BCF-24/65/110, BCM-110
2-13. CONDENSATION	2. Bend out the clips securing the rodent cover on the back of
EVAPORATOR (Continued)	the unit, and pull the cover down.

3.Disconnect the wires to the evaporator.

4.Pull up on the bottom of the evaporator to disengage the evaporator from the bracket. The evaporator is snapped into place. No hardware is securing it.

5.Replace evaporator in reverse order.

2-14. DOOR SEAL	1. Open door and pull out on a corner of the seal until seal
	clears the retainer.

2.Continue around the door, pulling the seal from the door.

3.Install new seal, starting with the four corners first.

603

2-7

Image 7

Contents COMPRESSOR, Drier MaintenanceMaintenance Hints IntroductionControl Board Remove the electrical power to the unitContactor Door Frame Heater Evaporator FAN Install new fan in reverse orderEvaporator Probe AIR ProbeFrigiprobe Condensation Evaporator Fuse and Fuse HolderBend out the clips securing the rodent cover on the back CondensationEvaporator Unit, and pull the cover down Start Capacitor RUN CapacitorStart Relay Procedure Preventive MaintenanceFrequency Wiring Diagrams BCF/BCM-110 Wiring Diagram BCF-24/65 Refrigeration Diagram BCF-24/65 Model BCF-24/65/110, BCM-110 Electrical/Refrigeration Diagram Wiring Information of PC Board

2-13. CONDENSATION

2. Bend out the clips securing the rodent cover on the back of

EVAPORATOR (Continued)

the unit, and pull the cover down.