Ryobi ELL0006 manual Operating the Laser Level, See Figures 10

Page 11

OPERATION

using a TRIPOD

See Figure 10.

The laser level has a 5/8 in.-20 threaded fitting for attaching to a tripod base (not included). This method of mounting is ideal for leveling kitchen cabinets, countertops, window framing, and more.

If a 1/4 in. tripod fitting is needed, thread the adaptor inside the 5/8 in. mounting hole and tighten with a flat blade screw- driver before attaching to tripod.

CAUTION:

Use caution when using laser level in base. Do not orient in a way that will allow the laser level to slide or fall out of the base.

OPERATING THE LASER LEVEL

See Figures 10 - 11.

Warning:

The typical alkaline battery life for the AIRgrip vacuum system is four hours. Replace with fresh alkaline batteries prior to four hours of use. Failure to heed this warning could result in damage to the product and/or serious personal injury.

Before initial use, wipe AIRgrip vacuum base with a damp cloth to remove any residue.

Place the level in the area where you want the laser lines projected. Refer to Using the AIRgrip Vacuum or Using the Multi-Function Base earlier in this manual if adhering to a surface is desired.

Turn on the laser.

Rotate the laser housing to position the laser lines in the general area desired. Then use the adjustment knobs to fine-tune the line position.

NOTE: Due to construction inaccuracy, walls may not be perfectly straight. This may cause the laser to have slight variances when in the level position.

The laser level is self-leveling when used within the prod- uct specifications listed earlier in this manual. If operat- ing outside of the specifications listed, the laser line will appear to have a textured pattern.

laser level

 

mounted

 

on a tripod

Fig. 10

 

ROTATIONAL

ADJUSTMENT KNOB

LINE HEIGHT

ADJUSTMENT

KNOBS

Fig. 11

WARNING:

Use of controls or adjustments or performance of pro- cedures other than those specified herein may result in hazardous radiation exposure.

11

Image 11
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsGeneral Safety Rules Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning ServiceProduct Specifications FeaturesKnow Your Crosshair Laser Level Adjustment KnobsLaser Housing Laser POWER/MODE SelectorOperation AssemblySee Figure Using the Airgrip VacuumTurning the Vacuum Base ON/OFF Turning the Laser ON/OFFSee Figures 8 Using the multi-function baseSee Figures 10 Operating the Laser LevelGeneral Maintenance MaintenanceTroubleshooting Service Model NO. and Serial no HOW to Order Repair Parts
Related manuals
Manual 14 pages 51.2 Kb