Ryobi P420 manual To Install Battery Pack, To Remove Battery Pack, Switch Trigger

Page 12

OPERATION

TO INSTALL BATTERY PACK

See Figure 4.

Place the battery pack on the tool.

Make sure the latches on each side of the battery pack snap into place and the battery pack is secured on the tool before beginning operation.

TO REMOVE BATTERY PACK

See Figure 4.

Depress the latches on the side of battery pack.

Remove the battery pack from the tool.

WARNING:

Battery products are always in operating condition. Therefore, the switch should always be locked when not in use or carrying at your side.

LOCK-OFF BUTTON

See Figure 5.

The lock-off button is located on the handle above the switch trigger. You must depress the lock-off button in order to pull the switch trigger. The lock resets each time the trigger is released.

SWITCH TRIGGER

See Figure 5.

To turn the grinder ON, depress and hold lock-off button, then depress the switch trigger. To turn it OFF, release the switch trigger.

BATTERY PACK

Fig. 4

LOCK-OFF

BUTTON

SWITCH

TRIGGER

Fig. 5

12

Image 12
Contents OPERATOR’S Manual Save this Manual for Future ReferenceWarranty IntroductionGeneral Safety Rules Electrical SafetyPersonal Safety Work AreaSpecific Safety Rules ServiceImportant Safety Instructions Safety Rules for ChargerSymbols Name DESIGNATION/EXPLANATIONSymbol Signal Meaning Features Product SpecificationsAssembly Charging the Battery Pack OperationAttaching the Side Handle ApplicationsCharging a Cool Battery Pack Charging a HOT Battery PackTo Install Battery Pack To Remove Battery PackSwitch Trigger Installing Grinding Wheel Positioning the Guard See Figures 7Operating the Grinder To operate the grinderMaintenance General MaintenanceBattery Pack Removal and Preparation for Recycling BatteriesReplacing the Guard Clamp NUT Grinding Wheel Disc Flange To Tighten2 in., 18 Volt Angle Grinder