Ryobi P420 manual Positioning the Guard, See Figures 7

Page 14

OPERATION

POSITIONING THE GUARD

See Figures 7 - 10.

The guard on the grinder should be correctly installed depending on which side the handle is mounted. Never use the grinder without the guard correctly in place.

WARNING:

Never place the guard so that it is in front of the grinder as shown in figure 7. This could result in serious injury because sparks and loose particles thrown from the grinding wheel would be directed toward the operator. Always place the guard in the correct location as shown.

To adjust the guard:

Remove battery from the grinder.

Unlock the guard clasp by pulling the clasp out, away from the grinder.

Rotate the guard to its correct position as shown.

NOTE: Be sure the raised ridge on the guard is seated in the groove on the bearing cap. Never use the grinder without the guard in place and properly adjusted.

ROTATING FOOT

See Figure 11.

The foot of the grinder can be rotated up to 270° to the left for easier access to hard to reach areas. Stops are located at 90°, 180°, and 270°.

Fig. 7

TOOLLESS

GUARD

CLASP

Fig. 8

SIDE HANDLE ON LEFT SIDE OF GRINDER

TOOLLESS

GUARD

Fig. 9

14

Image 14
Contents OPERATOR’S Manual Save this Manual for Future ReferenceWarranty IntroductionPersonal Safety General Safety RulesElectrical Safety Work AreaSpecific Safety Rules ServiceImportant Safety Instructions Safety Rules for ChargerSymbols Name DESIGNATION/EXPLANATIONSymbol Signal Meaning Features Product SpecificationsAssembly Attaching the Side Handle Charging the Battery PackOperation ApplicationsCharging a Cool Battery Pack Charging a HOT Battery PackSwitch Trigger To Install Battery PackTo Remove Battery Pack Installing Grinding Wheel Positioning the Guard See Figures 7Operating the Grinder To operate the grinderBattery Pack Removal and Preparation for Recycling MaintenanceGeneral Maintenance BatteriesReplacing the Guard Clamp NUT Grinding Wheel Disc Flange To Tighten2 in., 18 Volt Angle Grinder