RULES FOR SAFE OPERATION FOR GRINDERS
■Grinding wheel and guard must be securely attached as described in this operating manual before connecting the grinder to a power source.
■Grinding wheels must be stored in a dry place.
■Before attaching the grinding wheel, inspect it for visible defects. If cracked, chipped, or warped, do not install it.
■Do not overtighten the clamp nut on the grinding wheel. Excessive tightening can cause the wheel to crack during operation
■Make sure that the guard is in good condition and securely installed before operating grinder.
■Do not clamp the grinder in a vise or use as a fixed grinder.
■Never turn on the grinder with the grinding wheel or any rotating parts touching the workpiece.
■Use only grinding wheels in compliance with ANSI standard B7.1 and rated greater than 11,000 rpm.
■Do not use the grinder if the disc flange or clamp nut is missing or if the spindle is bent.
■Always hold the grinder securely with two hands while working and at all times when it is running.
■Never cover the air vents in the motor housing with your hands while operating the grinder.
■Hold the tool away from your body while it is running. Keep your hands away from the abrasive attachments.
■Dust and waste materials should not be allowed to build up in the workshop. Hot metal sparks could start a fire.
■Do not remove the soft paper in the center of the grinding wheel. NOTE: If this paper has been previously removed, insert some soft rubber or paper between the grinding wheel and disc flange.
■Do not enlarge or alter the center hole of the grinding wheel as this could result in breaking it.
■Use only the normal grinder surface. Never use the side or upper surfaces for cutting.
■KEEP THE TOOL AND ITS HANDLE DRY, CLEAN, AND FREE FROM OIL AND GREASE. Always use a clean cloth when cleaning. Never use brake fluids, gasoline,
UNPACKING
With the exception of the side handle and grinding wheel, your angle grinder has been shipped completely assembled.
■Carefully remove the grinder and accessories from the box. Make sure that all items listed in the packing list are included.
■Inspect grinder carefully to make sure no breakage or damage has occurred during shipping.
■If any parts are damaged or missing, contact your nearest Ryobi dealer to obtain replacement parts before attempting to operate grinder.
■Do not discard the packing material until you have carefully inspected and satisfactorily operated grinder.
PACKING LIST
Angle Grinder With Guard
Grinding Wheel
Side Handle
Wrench
Operator's Manual
Warranty Registration Card
WARNING:
If any parts are missing, do not operate your grinder until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
WARNING:
The operation of any grinder can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields.
Page 6