Ryobi SGL1150 Adjustments, Installing the Side Handle, Installing the Grinding Wheel

Page 8

ADJUSTMENTS

WARNING:

Your grinder should never be connected to power supply when you are assembling parts, making adjustments, installing or removing grinding wheels, or when not in use. Disconnecting your grinder will prevent accidental starting that could cause serious injury.

INSTALLING THE SIDE HANDLE

See Figure 2.

UNPLUG YOUR GRINDER.

WARNING:

Failure to unplug your grinder could result in accidental starting causing serious injury.

GEAR

HOUSING

SIDE

HANDLE

Fig. 2

Install the side handle by screwing it into the side of the gear housing.

NOTE: The handle can be installed on either the left or right side of the grinder, depending on operator prefer- ence. It must always be used to prevent loss of control and possible serious injury.

Tighten side handle securely.

INSTALLING THE GRINDING WHEEL

See Figure 3.

UNPLUG YOUR GRINDER.

TO

TIGHTEN

TO

LOOSEN

WRENCH

CLAMP

NUT

GRINDING

WHEEL

WARNING:

Failure to unplug your grinder could result in accidental starting causing serious injury.

DISC

FLANGE

Your grinder is shipped with the disc flange and clamp nut attached to the spindle.

Depress spindle lock button and rotate clamp nut until spindle locks.

Loosen and remove clamp nut from spindle. Do not remove disc flange.

Make sure flats on the bottom of disc flange are engaged with flats on spindle.

Place the grinding wheel over the spindle with the concave side of the wheel facing up.

WARNING:

Always install grinding wheel with the depressed center against the disc flange as shown in figure 3. Failure to do so will cause the grinding wheel to crack when tightening the clamp nut. This could result in serious personal injury because of loose particles breaking off and being thrown from the grinder.

SPINDLE

FLAT(S)

SPINDLE

LOCK BUTTON

Fig. 3

Thread the clamp nut on the spindle with the flat side of the nut facing up. Fit the raised, small diameter portion of the clamp nut into the hole in the grinding wheel and finger tighten.

Depress the spindle lock button and rotate the wheel clockwise until the spindle locks in position.

Securely tighten the clamp nut with the wrench provided.

Page 8

Image 8
Contents Save this Manual for Future Reference Thank YOU for Buying a Ryobi Angle GrinderTypical Application SGL1150 Angle GrinderGeneral Safety Rules Work AreaSpecific Safety Rules for Grinders Rules for Safe OperationSymbol Name DESIGNATION/EXPLANATION SymbolsFeatures Packing List Rules for Safe Operation for GrindersUnpacking Trigger Switch with LOCK-ON Feature Know Your Angle GrinderSpindle Lock Button Heavy Duty MotorInstalling the Grinding Wheel AdjustmentsInstalling the Side Handle Incorrect Location of Guard OperationGuard Location Switch LOCK-ON FeatureLOCK-ON Button Trigger Switch GrindingClamp Screw Spindle Bearing CAP Flats MaintenanceGuard Replacement Double Insulation GeneralLubrication 2 in mm Angle Grinder Model SGL1150 Ryobi TECHNOLOGIES, INC