Ryobi HP962, HP1202M Specifications, Important Information for Recharging HOT Batteries, Battery

SPECIFICATIONS:

	HP962	HP1202M
Chuck	3/8 in. Keyless	3/8 in. Keyless
Motor	DC Motor 9.6V	DC Motor 12.0V
Switch	Variable Speed	Variable Speed
No Load Speed	0 - 550 RPM	0 - 550 RPM
Clutch	24 Positions	24 Positions
Charger Input	120V, 60 Hz, AC Only	120V, 60 Hz, AC Only
Charge Rate	3-6 Hours	3-6 Hours

IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES

When using your drill-driver continuously, the batteries in your battery pack become hot. You should let a hot battery pack cool down for approximately 30 minutes before at- tempting to recharge.

Note: This situation occurs when continuous use of your drill-driver causes the batteries to become hot. It does not

occur under normal circumstances. Refer to "Charging Your Drill-Driver"for normal recharging of batteries. If the charger/charging assembly does not charge your battery pack under normal circumstances, return both the battery pack and charger/charging assembly to your nearest Ryobi Authorized Service Center for electrical check.

DISPOSAL OF THE EXHAUSTED BATTERY

		CYC					To preserve natural resources, please
	E		L
R				E			recycle or dispose of properly.
		R B R C
							This product contains nickel-cadmium
1		N i	C d			7	battery. Local, state, or federal laws may
.					3		prohibit disposal of Nickel-Cadmium
8
				8
0
	0. .
		8	22	8			batteries in ordinary trash.

Consult your local waste authority for information regarding available recycling and/or disposal options.

For more information on battery recycling call 1-800-8

BATTERY.

WARNING:

Do not attempt to disassemble the battery pack. Fire or injury may result.

BATTERY PACK PREPARATION FOR RECYCLING

WARNING:

Upon removal, cover the battery pack's terminals with heavy duty adhesive tape. Do not attempt to destroy or disassemble battery pack or remove any of its components. Also, never touch both terminals with metal objects and/or body parts, as short circuit may result. Keep away from children. Failure to comply with these warnings could result in fire and/or serious injury.

WARNING:

The operation of any power tool can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields. Always wear eye protection which is marked to comply with ANSI Z87.1.

Page 6