OPERATION
REMOVING BITS
See Figure 6.
■Place the direction of rotation selector in center position. This will turn off the power to your drill.
■Loosen the chuck jaws from drill bit.
■To loosen: grasp and hold the collar of the chuck with one hand, while rotating chuck body with your other hand.
Note: Rotate chuck body in the direction of the arrow marked RELEASE to loosen chuck jaws. DO NOT use a wrench to tighten or loosen the chuck jaws.
■Remove drill bit from chuck jaws.
MAG TRAY™
See Figure 8.
For convenience, your drill has a Mag Tray™ to place small parts when doing a variety of tasks.
SCREWDRIVING
TORQUE ADJUSTMENT
(Driving power of your drill-driver)
When using your
The torque is adjusted by rotating the torque adjustment ring. See Figure 8. The torque is greater when the torque adjust- ment ring is set on a higher setting. The torque is less when the torque adjustment ring is set on a lower setting.
The proper setting depends on the type of material and the size of screw you are using.
TO ADJUST TORQUE
■ Identify the twenty four torque indicator settings located on the front of your drill. See Figure 8.
■Rotate adjustment ring to the desired setting.
•1 - 4 For driving small screws.
•5 - 8 For driving screws into soft material.
•9 - 12 For driving screws into soft and hard materials.
•13 - 16 For driving screws in hard wood.
•17 - 20 For driving large screws.
•21 
BIT STORAGE
See Figure 9.
When not in use, bits provided with your drill can be placed in the storage area located on the top of your drill.
LEVEL DRILLING
See Figure 10.
A convenient new feature provided with your drill is a level. It is recessed in the motor housing on top of your drill. It can be used to keep drill bit level during drilling operations.
Page 10
TO DECREASE
TORQUE
8
6
4 
2 
TORQUE
ADJUSTMENT
RING
TO INCREASE
TORQUE
MAG TRAY™
(SCREW HOLDER)
Fig. 8
SCREWDRIVER BIT | BIT STORAGE |
| AREA |
8
6
4 
2 
SCREWDRIVER
BIT
Fig. 9
10 
8
6 
4 
2 
20 
18 16 
LEVEL
Fig. 10