45
English
To change the transmittable signals for
operating another manufacturer’s VCR
1. Set the remote control mode to “AUDIO/TV/
VCR.”
2. Press and hold VCR 1 .
3. Press VCR 1.
4. Enter manufacturer’s code (three digits) using
buttons 1 – 9, and 0.
See the list on pages 48 and 49 to find the code.
Examples: For a JVC product, press 0, 0, then 8.
For a Funai product, press 0, 0, then 0.
5. Release VCR 1 .
Following button can be used for operating the VCR (with the
remote control mode selector set to “AUDIO/TV/VCR”):
VCR 1 :Turns on and off the VCR.
After pressing VCR 1 or VCR 1 CONTROL (with the remote
control mode selector set to “AUDIO/TV/VCR”), you can
perform the following operations on the VCR:
CHANNEL +/–: Changes the TV channels on the VCR.
1 – 10, 0, 100+ (+10): Selects the TV channels.
100+ (+10) button will function as
the ENTER button if your VCR
requires pressing ENTER after
selecting a channel number.
PLAY: Starts playback.
1:Rewinds a video tape.
¡:Fast winds a video tape.
STOP: Stops operation.
PAUSE: Pauses.
REC: Starts recording or enters recording pause.
Notes:
• Refer to the manual supplied with your VCR.
• You can use either VCR 1 button or the VCR 1 CONTROL
button to activate the buttons listed above. If you press VCR 1,
the playing source also changes. On the other hand, if you
press VCR 1 CONTROL, the playing source does not change.
6. Try to operate your VCR by pressing VCR 1 .
When your VCR turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand of
VCR, try each one until the correct one is entered.
To change the transmittable signals for
operating a CATV converter or DBS tuner
1. Set the remote control mode to “CATV/DBS.”
2. Press and hold TV/CATV/DBS .
3. Press TV/DBS.
4. Enter manufacturer’s code (three digits) using
buttons 1 – 9, and 0.
See the list on pages 47 and 48 to find the code.
Examples: For a Marantz product, press 2, 0, then 0.
For a Philips product, press 2, 0, then 0.
5. Release TV/CATV/DBS .
After setting the remote control mode selector to “CATV/DBS,”
you can perform the following operations on the CATV
convertor or on the DBS tuner:
TV/CATV/DBS :Turns on and off the CATV converter
or DBS tuner.
CHANNEL +/–: Changes the channels.
1 – 10, 0, 100+ (+10): Selects the channel.
100+ (+10) button will function as the
ENTER button if your equipment
requires pressing ENTER after
selecting a channel number.
Note:
Refer to the manual supplied with your CATV converter or DBS
tuner.
6. Try to operate your CATV converter or DBS
tuner by pressing TV/CATV/DBS .
When your CATV converter or DBS tuner turns on or off, you
have entered the correct code.
If there are more than one code listed for your brand of
CATV converter or DBS tuner, try each one until the correct
one is entered.
EN42_52.RX-889P[US, UB]/f 99.4.12, 5:37 PM45