JVC LVT0178-001A, RX-889PGD manual Adjusting the Surround Modes

3. Adjust the effect level.	BALANCE/SURROUND
1) Press BALANCE/SURROUND		ADJUST
ADJUST repeatedly until “DSP
EFFECT” appears on the display.
The display changes to show the current
setting.		MULTI JOG

2)Turn MULTI JOG to select the effect level.

•As you turn it, the effect level changes as follows:

DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3

DSP EFFECT 5DSP EFFECT 4

As the number increases, the selected DAP mode becomes stronger.

From the remote control:

1. Press SURROUND MODE	SURROUND
repeatedly until the DAP mode —	MODE
LIVE CLUB, DANCE CLUB,
HALL, or PAVILION — appears
on the display.

The DSP and the selected DAP mode indicators also light up on the display.

SOUND

2. Press SOUND.

The 10 keys are activated for sound adjustments.

3. Adjust the speaker output levels.		REAR•L
	5	6
• To adjust the left rear speaker level, press		ENTER
REAR•L –/+ (from –10 dB to +10 dB).
• To adjust the right rear speaker level, press
REAR•R –/+ (from –10 dB to +10 dB).		REAR•R

Adjusting the Surround Modes

Once you have adjusted the Surround modes, the adjustment is memorized for each Surround mode.

Dolby/DTS/MPEG Surround adjustments

Before you start, remember...

•Make sure that you have set the speaker information correctly (see page 14).

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•You cannot adjust the rear speaker output levels when you have set “REAR SPK” to “NONE.” See page 14.

•You cannot adjust the center speaker output level and center tone when you have set “CENTER SPK” to “NONE.” See page 14.

From the remote control:
1. Press SURROUND MODE	SURROUND
repeatedly until the mode — PRO	MODE
LOGIC, DOLBY DIGITAL, DTS
SURROUND, or MPEG
SURROUND — appears on the
display.

•When “PRO LOGIC” is selected, the PRO LOGIC indicator lights up on the display.

Note:

You can also press SURROUND ON/OFF to activate an appropriate Surround mode — PRO LOGIC, DOLBY DIGITAL, DTS SURROUND, MPEG SURROUND. Each time you press the button, the Surround mode turns on and off alternately.

SOUND

2. Press SOUND.

The 10 keys are activated for sound adjustments.

English

4.Press EFFECT to select an effect level you want.

•Each time you press the button, the effect level changes as follows:

8 9

EFFECT

7/P

3. Press TEST to check the speaker					TEST
	output balance.
				4
	“TEST TONE L” starts flashing on the
	display, and a test tone comes out of the
	speakers in the following order:
		TEST TONE L	TEST TONE C		TEST TONE R
		(Left front speaker)	(Center speaker)		(Right front speaker)

DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3

DSP EFFECT 5 DSP EFFECT 4

As the number increases, the selected DAP mode becomes stronger.

TEST TONE LS	TEST TONE RS
(Left rear speaker)	(Right rear speaker)

24