OPERATION
WARNING:
Make sure to insert drill bit straight into chuck jaws. Do not insert drill bit into chuck jaws at an angle and then tighten, as shown in Figure 5. This could cause drill bit to be thrown from drill, resulting in possible serious personal injury or damage to the chuck.
U
N
L
O
C
K
WRONG
Fig. 5
REMOVING BITS
See Figure 4.
nUnplug your drill.
WARNING:
Failure to unplug your drill could result in accidental starting causing serious injury.
nLoosen the chuck jaws from drill bit.
nTo loosen: grasp and hold the collar with one hand, while rotating chuck body with your other hand.
Note: Rotate chuck body in the direction of the ar- row marked UNLOCK to loosen chuck jaws.
nDo not use a wrench to tighten or loosen the chuck jaws.
nRemove drill bit from chuck jaws.
ADJUSTABLE TORQUE CLUTCH
Your drill is equipped with an adjustable torque clutch for driving different types of screws into different materials. The proper setting depends on the type of material and the size of screw you are using.
TO ADJUST TORQUE
nIdentify the twenty four torque indicator settings located on the front of your drill. See Figure 6.
nRotate adjusting ring to the desired setting.
•1 - 4 For driving small screws.
•5 - 8 For driving screws into soft material.
•9 - 12 For driving screws into soft and hard materials.
•13 - 16 For driving screws in hard wood.
•17 - 20 For driving large screws.
•21 
TO DECREASE | ADJUSTING | |
TORQUE | ||
RING | ||
|
U 
N
L
O
C
K 
TO INCREASE
TORQUE
Fig. 6
11