Features

SPECIFICATIONS:

Chuck Capacity	1/16 in. to 3/8 in.
	(1.6 mm to 10 mm)
Input	120 V, 60 Hz, AC only, 4.5 Amps.
Switch	Variable Speed
No Load Speed	0-1000/min.
Clutch	24 Positions

KNOW YOUR DRILL-DRIVER

See Figure 1.

Before attempting to operate your drill-driver, familiarize yourself with all operating features and safety require- ments.

WARNING:

Carefully read through this entire operator's manual before using your new drill-driver. Pay close attention to the Safety Rules, Warnings and Cautions. If you use your drill-driver properly and only for what it is intended, you will enjoy years of safe, reliable service.

WARNING:

Do not allow familiarity with your drill-driver to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury.

KEYLESS CHUCK

Your drill-driver has a keyless chuck that allows you to hand tighten or release drill bit in the chuck jaws.

SWITCH

To turn your drill-driver ON, depress the switch trigger. Release switch trigger to turn your drill-driver OFF.

FORWARD/REVERSE SELECTOR

(DIRECTION OF ROTATION SELECTOR)

Your drill-driver has a forward/reverse selector located above the switch trigger.

VARIABLE SPEED

This tool has a variable speed switch that delivers higher speed with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.

BIT STORAGE

When not in use, bits provided with your drill-driver can be placed in the storage area located in the motor housing.

LEVEL

Two levels are recessed in the motor housing of your drill-driver. They can be used to keep drill bits level during both horizontal and vertical drilling operations.