Ryobi manual Ryobi 3/8 in mm DRILL-DRIVER Model NO. D45CK

Page 15

RYOBI 3/8 in. (10 mm) DRILL-DRIVER – MODEL NO. D45CK

The model number will be found on a plate attached to the motor housing. Always mention the model number in all correspondence regarding your DRILL-DRIVERor when ordering parts.

SEE BACK PAGE FOR PARTS ORDERING INSTRUCTIONS

SEE NOTE

PARTS LIST

Key No.	Part No.	Description	Quan.
1	6612001	Chuck Screw	1
2	940214077	Data Plate	1
3	940185030	Logo Plate	1
4	690032011	3/8 in. (10 mm) Chuck	1
	983000-473	Operator’s Manual

NOTE: The assembly shown represents an important part of the Double Insulated System. To avoid the possibility of alteration or damage to the system, service should be performed by your nearest authorized service center.

15

Image 15

Contents Save this Manual for Future Reference Operators Manual 3/8 in. Drill-Driver D45CKIntroduction Table of ContentsWork Area General Safety RulesElectrical Safety Personal SafetySpecific Safety Rules ServiceAdditional Safety Rules Symbol Name DESIGNATION/EXPLANATION SymbolsSymbol Signal Meaning Extension Cords ElectricalDouble Insulation Electrical ConnectionFeatures Operation ApplicationsLOCK-ON Button Reversible Installing BitsWrong Adjustable Torque ClutchTo Adjust Torque Removing Bits Drilling Level Drilling Screwdriver Bits BIT Storage Area HEX KEY Mallet Chuck Jaws Torque Adjusting RingChuck Removal To Retighten a Loose ChuckMaintenance GeneralLubrication See Back page for Parts Ordering Instructions See Note Ryobi 3/8 in mm DRILL-DRIVER Model NO. D45CKService Model NO. and Serial no