Ryobi TS1302 manual Table Extensions, Stop Block, See Figures 13, 14

Page 13

ASSEMBLY

TABLE EXTENSIONS

See Figures 13, 14, and 15.

If you plan to use the stop block, slide the stop block on the back arm of the desired table extension first. See Figure 13.

To install table extensions, insert the ends of extensions into the holes in the sides of the base. See Figures 13 and 14. Adjust the extensions to the desired length.

Secure them in place by positioning a clamp bracket under each table extension beneath the miter table. Orient each clamp bracket as shown in figure 15.

Secure each clamp bracket in place with a clamp bracket screw. The clamp bracket screw threads through the clamp bracket and tightens against bracket support on bottom of miter table, securing clamp bracket against table extension.

STOP BLOCK

See Figures 13 and 16.

The stop block is included with the Table extensions and is useful as a stop for making repetitive cuts to the same length. It can be installed on either side of the saw base:

Slide the stop block on the back arm of either table extension, then insert the table extensions into the saw base. See Figure 13.

Use the small wing screw to secure the stop block to the table extensions. See Figure 13.

Loosen the small wing screw and adjust the stop block the desired distance from the blade for the cut to be made. For accurate placement of the stop block, mea- sure the distance from the teeth set on the blade to the stop block.

Tighten wing screw securely.

Make a test cut in scrap material and measure the length of the workpiece.

Make any necessary adjustments.

WARNING:

Always make sure your miter saw is securely mounted to a workbench or an appropriate workstand. Failure to do so could result in an accident resulting in possible serious personal injury.

TABLE

EXTENSION

45

MITER

30

SAW BASE

 

15

 

31.62

30

22.5

45

 

 

 

Fig. 14

SAW VIEWED FROM BOTTOM

MITER

SAW BASE

BRACKET

SUPPORT

 

CLAMP

TABLE

BRACKET

ASSEMBLED

EXTENSION

 

CLAMP

BRACKET

CLAMP

BRACKET SCREW

Fig. 15

STOP BLOCK

SMALL

WING SCREW

45

TABLE

EXTENSION

15

30

5 4

30

STOP BLOCK

0

45

45 30

15

30

MITER

SAW BASE

Fig. 13

Fig. 16

Page 13

Image 13
Contents Save this Manual for Future Reference Product Specifications Table of ContentsIntroduction Rules for Safe Operation Safety and International SymbolsDouble Insulation Read ALL Instructions Blade Coasts After Being Turned OFF Freehand Glossary of Terms for WoodworkingUnpacking and Checking Contents Features Spindle Lock Button Miter Lock HandleTrigger Lock Positive Stops on Miter TableMounting Hole Optional AccessoriesElectrical Connection Trace Holes AT These Locations For Hole PatternTo Install Blade AssemblyDust Guide Miter TightenDust BAG Stop Block Table ExtensionsSee Figures 13, 14, See Figures 13Pivot Adjustments Travel Pivot Adjustment AdjustmentsAuthorized Service Center See Figures 17 Squaring the Miter Table to the FenceFence Miter Table Blade SlotSee Figures 21 Squaring the SAW Blade to the FenceFence Miter Blade Square with FenceApplications OperationCutting with Your Miter SAW CrosscuttingLong Workpiece Support Long WorkpiecesWorkpiece Supports Clamping Wide Workpieces Cutting Warped MaterialRight Wrong Wide BoardGeneral MaintenanceLubrication Extension CordsProblem Cause Solution TroubleshootingRyobi TECHNOLOGIES, INC Operators Manual 10 in mm Miter Saw Model TS1302