RULES FOR SAFE OPERATION (Continued)
7.DO NOT MAKE ADJUSTMENTS UNTIL CUTTER OR BLADE HAS COME TO A COMPLETE STOP AND TOOL HAS BEEN DISCONNECTED FROM POWER SOURCE.
8.FEED WORKPIECE AGAINST ROTATION OF CUTTER.
9.DO NOT USE AWKWARD HAND POSITIONS.
10.KEEP FINGERS AWAY FROM REVOLVING CUTTER, USE FIXTURES WHEN NECESSARY.
11.WHENEVER POSSIBLE, ALWAYS USE DUST COVER FOR OVERHEAD GUARDING.
12.DO NOT REMOVE JAMMED CUTOFF PIECES UNTIL CUTTER OR BLADE HAS STOPPED AND TOOL HAS BEEN DISCONNECTED FROM POWER SOURCE.
13.HOLD WORKPIECE FIRMLY AGAINST THE TABLE.
14.UNUSED SAW MAY CAUSE PERSONAL INJURY. DISCONNECT MOTOR CORD FROM THE RECEPTACLE ON YOUR SAW AND PLUG ACCESSORY POWER CORD INTO THE RECEPTACLE. ALWAYS USE THE SAW'S MASTER SWITCH TO TURN THE ACCESSORY "ON" AND "OFF".
INTRODUCTION
As mentioned previously, this kit gives you the capability of mounting a router or jig saw on the accessory table of your BT3000. A router mounted on the accessory table will pro- vide expanded capabilities for making rabbets, grooves, chamfers, dovetails, and mortise and tenon joints. A jig saw mounted on the accessory table will provide expanded capabilities for cutting curves, scrollwork, and intricate pat- terns.
The circle cutting jig included in this kit enables you to easily cut circular patterns in both large and small stock with either a router or jig saw.
The additional versatility gained from use of this kit will turn your BT3000 table saw into a remarkable woodshaping center.
IMPORTANT NOTE
This router kit has been specifically designed for use with the Ryobi Model RE600 Electronic Router Only. The hole pattern on the mounting plate has not been drilled to accommodate other routers on the market.
This jig saw kit is used to mount a jig saw on the accessory table of your BT3000 table saw. Ryobi jig saws plus many other brands can be mounted using the parts supplied in this kit. Before operating the jig saw, make sure the front and rear clamping brackets properly secure the jig saw base to the mounting plate. Care must be taken to insure that the jig saw blade does not come in contact with the throat plate, accessory table, or any part of the assembly during operation. Visually inspect all areas of moving parts prior to connecting the jig saw to power supply.
CHECKING PARTS
Separate all parts from packing materials. Check your parts with the parts list on page 3. Refer to Figure 1 if you are unsure about the description of any part. If any parts are missing, delay assembly of this kit until you have obtained the missing part(s).
WARNING:
Attempting to assemble the Router and Jig Saw Mounting kit or to use in any way without obtaining any missing parts and installing them correctly, could result in an accident resulting in possible serious injury.
TOOLS NEEDED
Tools needed for assembly of this kit are a phillips screw- driver, two slotted screwdrivers, and an adjustable wrench. Note: Adjustable wrench will be used to tighten threaded post into the special 5/16 in.
WARNING:
Unplug the power supply cord of your BT3000 from electrical outlet before you begin mounting this kit. It should remain disconnected until the mounting operation is complete, all attachments are installed properly, and they have been checked to make sure they are secure. Failure to unplug your saw could result in accidental starting causing possible serious personal injury.
UNPACKING
Your new router and jig saw mounting kit includes two separate mounting plates, two guide fences with guide blocks, a dust cover assembly, a throat plate, plus the necessary brackets and connecting hardware required to mount a Ryobi Model RE600 Electronic Router to the accessory table of your BT3000 table saw. It also includes connecting hardware required to mount Ryobi jig saws to the accessory table of your BT3000 table saw .
Page 2