Router Mounting Contd, To Install Post

ROUTER MOUNTING (Cont'd)

TO INSTALL GUIDE FENCE BRACKETS

See Figure 4.

1.Align each guide fence bracket with two of the special 5/16 in. T-nuts in channel on top of rip fence.

2.Secure guide fences to rip fence with 5/16 in. washers and 5/16 in. x 1/2 in. knob bolts supplied. Note: As shown in figure 4, center T-nut is not used with guide fences.

TO INSTALL POST

See Figure 4.

1.Place spacer provided on threaded end of post.

2.Thread post thru spacer into remaining 5/16 in. T-nut in top channel of rip fence.

3.Tighten post securely with an adjustable wrench. Note: Adjustable wrench will fit flats on top of post.

TO INSTALL DUST COVER AND PIVOT ASSEMBLY

See Figure 4.

1.Place dust cover and pivot assembly on post as shown in figure 4.

2.It will slide up and down post as needed. When desired location is achieved, secure it in place by tightening knob nut attached to carriage bolt.

DUST COVER AND PIVOT ASSEMBLY	CARRIAGE BOLT (NOT SHOWN)

KNOB NUT

FLATS ON POST

POST

KNOB BOLTS

SPACER

5/16 in. WASHERS

GUIDE FENCE BRACKET	T-NUTS

RIP FENCE

Fig. 4

Page 5