Ryobi BT3000 Installing Router BIT, To Assemble Throat Plate, To Assemble Table Clamping Bracket

ROUTER MOUNTING (Cont'd)

TO ASSEMBLE RE600 ELECTRONIC ROUTER TO ROUTER MOUNTING PLATE

See Figures 5 and 6.

1.	Remove the subbase screws and subbase from your
	router.
2.	Figure 5 illustrates the correct orientation of parts and

8 MILLIMETER

SCREWS

RE600

ELECTRONIC

pieces for mounting your router to its mounting plate.

ROUTER

ROUTER

3.	Place router upside down on a workbench and align
	mounting plate holes with tapped holes in the base of
	your router.
4.	The switch handle of router should be facing the squared
	end of mounting plate. See Figure 5.
5.	Using the 8 mm flat head screws provided with your
	router, secure mounting plate to router.
6.	Once properly assembled, your router and mounting
	plate assembly should be similar to the illustration
	shown in figure 6.
7.	Tighten screws securely.

TO ASSEMBLE MOUNTING PLATE WITH ROUTER ATTACHED TO ACCESSORY TABLE

See Figure 7.

1.Place mounting plate under accessory table as shown in figure 7. Note: If desired you can remove accessory table, attach mounting plate with router, then reassemble complete assembly to your saw.

2.Secure mounting plate to accessory table using the four #1/4-20 x 1/2 in. flat head screws provided.

3.Tighten screws securely.

INSTALLING ROUTER BIT

Follow the instructions in the operator's manual of your router for this procedure. Install router bit and tighten securely in collet.

CAUTION:

Check to make sure it will not strike the accessory table or any metal surface.

MOUNTING

PLATE

FRONT OF ROUTER

Fig. 5

Fig. 6

THROAT PLATE

#1/4-20 SCREWS

ACCESSORY TABLE

TO ASSEMBLE THROAT PLATE

See Figure 7.

Orient the throat plate as shown in figure 7, align tab with slot in accessory table, then place throat plate in recessed area of accessory table. Recheck router bit to make sure it will not strike the throat plate.

TO ASSEMBLE TABLE CLAMPING BRACKET

See Figure 8.

The lever on the accessory table will tighten it securely to the front rail of your BT3000. However, the weight of your router and mounting plate, etc. may cause accessory table to be loose or have movement at the rear of the accessory table. To avoid this, install the table clamping bracket supplied with this kit. It can be used with a router mounted, with a jig saw mounted, or if desired it can be used with your BT3000 during

normal use.

Page 6

SLOT

ROUTER

WITH MOUNTING

PLATE ATTACHED

Fig. 7