UNPACKING
This tool has been shipped completely assembled except for the blade.
n Carefully remove the tool and accessories from the box.
nMake sure that all items listed in the packing list are included.
nInspect the tool carefully to make sure no breakage or damage occurred during shipping.
nDo not discard the packing material until you have care- fully inspected and satisfactorily operated the tool.
nIf any parts are damaged or missing, please call
PACKING LIST
Variable Speed Orbital Jig Saw
Blades (2)
Vacuum Attachment
Edge Guide
Case
Operator’s Manual
Warranty Registration Card
WARNING:
If any parts are missing do not operate your tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
ASSEMBLY
WARNING:
Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious personal injury.
TO INSTALL JIG SAW BLADES
See Figure 2.
nUnplug your saw.
�n Lift the clamping lever on the
�n Holding the clamping lever up, insert the saw blade as far as possible into the slot in the saw bar.
�n Check to make sure the back of the saw blade is centered in the groove of the roller guide.
�n Release the clamping lever. Make sure the blade is securely in place.
DUST PICK-UP FEATURE
See Figure 3.
For dust
To Install:
nUnplug the saw.
nSlide the vacuum attachment into the curved area at the rear of the saw base until it snaps into place.
nAttach vacuum attachment to a
nConnect vacuum hose to cleaner.
To Remove:
nUnplug the saw.
nRemove the vacuum attachment by pulling attachment from base.
CLAMPING |
|
LEVER | SAW BLADE |
|
Fig. 2
VACUUM ATTACHMENT
Fig. 3
10