OPERATION
ANGLE CUTTING (BEVEL CUTTING)
See Figures 12 and 13.
Bevel cutting angles may be adjusted from 0° to 45° right or left. Angles for cuts from 0° to 45° in 15° increments are marked on a scale on both the left and right side of the base. An arrow under the motor assembly provides an indicator at each of the above mentioned 15° increments. A protractor is recommended when accurate cuts are required.
n Unlock the base by moving the base locking lever for- |
| |
ward. | BASE | |
n Align the mark, on the base, of the desired angle with the | ||
LOCKING | ||
indication arrow located on the housing. | LEVER | |
n Once the desired angle is reached, tighten the base lock- |
| |
ing lever by moving the base locking lever under the motor |
| |
assembly. |
|
Fig. 12
Fig. 13
15