operation
0° BEVEL STOP
See Figure 26.
The saw has a 0° bevel stop that has been factory adjusted to assure 0° angle of the saw blade when making 90° cuts.
To check 0° bevel stop:
Unplug the saw.
Place the saw in an upside down position on a work- bench.
Check the squareness of the saw blade plate to the base of the saw using a combination square.
To adjust 0° bevel stop:
Unplug the saw.
Loosen bevel adjustment knob.
Loosen hex nut securing adjusting screw.
Turn screw and adjust base until square with saw blade.
Tighten hex nut and bevel adjustment knob securely.
WARNING:
Attempting a bevel cut without having the bevel ad- justment knob securely tightened can result in serious injury.
51 . 5
45
30
15 
BEVEL
ADJUSTMENT 0° BEVEL STOP KNOB
combination
SQUARE
ADJUSTING
SCREW
HEX NUT
BLADE
Fig. 26
21