ASSEMBLY
TRACKING THE BLADE
See Figure 10.
NOTE: Adjust blade tension properly before making tracking adjustments. Check that the blade guides are not interfering with the blade.
To Adjust:
Open the front cover by releasing the upper and lower latches. Watch the blade’s position on the upper tire through the tracking view window as, by hand, you slowly turn the upper wheel clockwise. If the blade moves away from the center of the tire, the tracking must be adjusted. Retighten hex nut.
If the blade has moved left or right of center:
NOTE: It may be necessary to loosen the hex nut for a larger range of adjustments. Be sure to retighten after adjusting.
Turn the blade tracking knob (clockwise if blade has moved left and counterclockwise if blade has moved right) while turning the wheel by hand until the blade moves back and rides in the center of the tire.
Check the position of the blade on the lower tire. The blade should be completely on the tire. If not, adjust the tracking until the blade is on both tires.
Rotate the upper wheel by hand in a clockwise direction for a few more turns. Make sure the blade stays in the same location on the tires. Readjust, if necessary, until blade is tracking properly.
Close front cover and relatch.
NOTE: The 1/8 in. blade may not track properly in the center of the wheel. It may be better to track this blade on the back half of the upper wheel.
ATTACHING THE WORKLIGHT
See Figure 11.
Open the cover of the saw housing.
Slide the worklight bracket into the slot at the back of the band saw housing and into the slots on the inside of the band saw.
Securely tighten the wing screw clockwise to hold the worklight firmly in place.
Close the saw housing cover.
IMPORTANT SAFETY INSTRUCTIONS
This worklight has a polarized plug (one blade wider than the other) as a feature to reduce the risk of electric shock. This plug will fit in a polarized outlet onlly one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless the plug can be fully inserted. Do not alter the plug.
BLADE
TENSION
KNOB
BLADE ON
WHEEL
TRACKING
VIEW
WINDOW
BLADE
TRACKING
KNOB
Fig. 10
WORKLIGHT
BRACKET
Fig. 11
15