TROUBLE SHOOTING
TROUBLEPROBABLECAUSE
CHART
REMEDY
Woodstrikes outfeed
table after passingover cutterhead
Ripples on planedsurface.
Planedsurface not straight.
Excessivegouging at endof cut.
90 ° and 45" cuts inaccurate
1.Bladesimproperly adjusted below surface of outfeedtable.
2.Infeedtable out of adjustment
1.Oneblade set higherthan other.
2.Dull blades.
3.Boardnot heldfirmly againstfenceor outfeed table
1. Infeedtable looseor out of adjustment.
,2. Bladesset too low.
1. Bladesset too highabove outfeedtable.
1.Fenceand tilt indicators not adjusted properly.
1.
2.Contact your nearest Sears store or service center.
1.
2.
3:Hold board firmly against fence and outfeed table.
1.Adjust infeed table, see Maintenance section.
2.
1. Reset blades.
1.
Cutter guard does not function properly.
Chip discharge clogs
Cutter slows down during operation
1.Returnspring broken, or spring has beenweakened.
1.Obstructionreducing air flow.
2.Cutter headspeedtoo slow.
3.Woodhas high moisture content.
1.Workfeed speedtoo fast.
2.Attempting to remove too much material
1.Replace spring immediately. Contact
your nearest Sears store or service center.
1.Remove obstruction.
2.Decrease feed speed.
3.Decrease feed speed.
1.Decrease feed speed.
2.Decrease depth of cut, make two or more cuts.
owners manual
Service
MODELNO.
149.236320
How To Order Repair Parts
S_FARS / CRRFT$MRN
51/8-INCH JOINTER-PLANER
Now that you have purchased your
WHEN ORDERING REPAIR PARTS, ALWAYS | GIVE | THE FOLLOWING INFORMATION: | |
• PART NUMBER | • | PART | DESCRIPTION |
• MODEL NUMBER: | • | NAME | OF ITEM: |
149.236320 |
|
| |
All parts listed may be ordered from any Sears Service Center and most Sears stores.
If the parts you need are not stocked locally, your order will be electronically transmitted to a Sears Repair Parts Distribution Center for handling.
SEARS, ROEBUCK AND CO., Dept. 698/731A, Sears Tower, Chicago, IL 60684
Printed in U.S.A.