To Check Depth of CUT Outfeed, Fence Adjustment

TO CHECK DEPTH OF CUT		OUTFEED
		TABLE
a. Place a straight edge on the outfeed table extending over the in-
feed	table.	MAX. DEPTH
		,OF CUT 1/8"
b. Measure from the surface of the infeed table to the bottom of the
straight edge. This will be the depth of cut.
NOTE:-This Jointer-Planer will make a maximum 1/8" deep cut. To
reduce the DANGER of kickback and possible injury, the depth of cut
should not exceed 1/16" when cutting wood wider than 1-112".
,_	CAUTION: MAKE SURE THE SWITCH IS OFF AND THE
	CORD tS UNPLUGGED BEFORE PERFORMING THIS CHECK.

2. FENCE ADJUSTMENT

The fence can be adjusted to cut angles from 0 ° to 45 °. Stop pins allow automatic setting to 0 °, 221/2 °, 30 ° or 45 ° in either the inboard or outboard direction.

TO ADJUST: Loosen fence lock knobs and lift the stop pins out and turn to lock out. Move the fence to the desired angle. If it is one of the commonly used angles listed above, release the stop pins and they will pop into place when the correct angle is reached. Tighten the fence lock knobs to lock the fence in place. For a less common angle or to fine tune to an angle less than the 5 ° divisions on the fence seg- ment. Pul! and lock out the stop pins and use theo ° to 5 ° scale on the tilt indicator to set the exact angle desired.

1.FOR OUTBOARD TILT add the reading on the tilt indicator to the reading on the fence segment.

2.FOR INBOARD TILT subtract the tilt indicator reading from the reading on the fence segment. Always tighten the lock knobs to maintain the desired setting.

3.CUTTER GUARD

The cutter guard provides protection over the cutter head. It must

always be in place and functioning properly.

Check the guard to make sure it is functioning properly.

a. Pass a !14" thick piece of wood over the cutter head between the guard and fence. The guard must return automatically.

STOP P

TILT

INDICATOR

FENCE

b. Open the cutter guard all the way until it stops and release it several times. It should always return to its original position.

CAUTION: IF THE CUTTER GUARD FAILS TO OPERATE PROPERLY, THE CUTTER GUARD RETURN SPRING WILL NEED REPLACING. CONTACT YOUR NEAREST SEARS STORE OR SERVICE CENTER FOR REPLACE- MENT SPRING AND INSTRUCTIONS BEFORE USING THE JOINTER--PLANER.

4, ON-OFF SWITCH

The operating positions of the "On-Off" switch are located on the front of your Jointer-Planer. Push the switch up to turn your Jointer- Planer "on" and down to turn your Jointer-Planer "off". The switch has a switch key which, when removed, allows the switch to be lock- ed in the "off" position. To activate the locking feature push switch to "off" position and pull switch key.

To turn Jointer-Planer "on" after it has been locked in the "off" posi- tion, the switch key must be replaced in the switch.

,_WARNING:	BE SURE	SWITCH	IS IN THE "OFF" POSITION
BEFORE PLUGGING JOINTER.PLANER INTO POWER SOURCE
FAILURE TO DO SO COULD RESULT IN ACCIDENTAL
STARTING	CAUSING	SERIOUS	INJURY.	SWITCH
				SWITCH

\ SWITCH KEY