Setting the alarm sound, Snoozing, Using the lamp

English 13

Setting the alarm sound

Follow steps 1 to 5 in section ‘Middle dial’ in this chapter. You can choose one of the following sounds:

-- Radio (Fig. 12)

-- Birds (Fig. 13)

-- Beep (Fig. 14)

-- African jungle (Fig. 15) -- Wind chimes (Fig. 16)

Snoozing

1Push down the control lever to the bottom position when the

alarm goes off.  (Fig. 17)

,, The lamp continues to be on at the selected intensity level, but the alarm sound stops.After 9 minutes, the wake-up sound is automatically played again.

Note:The 9-minute snooze time is fixed.This time cannot be adjusted.

Note: If you push down the control lever with too much force, it may jump back to off position.

Alarm demonstration

If you want to get a quick demonstration (60 seconds) of the gradually increasing light level and sound level, activate the test function of the appliance.

1Push the control lever down to the bottom position for a few seconds until TEST appears on the display (Fig. 18).

2Push the control lever down again to stop the demonstration.

Note:The appliance continues to run the alarm demonstration until you push down the control lever again.The test automatically stops after 9 hours.

Using the lamp

You can use the top dial to switch on the lamp as a bedside lamp and to set the light intensity.

1To switch on the lamp, press the top dial gently and release it.   (Fig. 19)

English 13