18English
Problem | Solution |
I do not hear | Perhaps you set a sound level that is too low.To set a |
the alarm | higher sound level, see chapter ‘Using the appliance’, |
sound when | section ‘Radio/volume’. |
the alarm goes |
|
off. |
|
| Perhaps you switched off the alarm function by |
| setting the control lever to the top position. |
| If you selected the radio as the alarm sound, the |
| radio may be defective. Switch on the radio after you |
| switch off the alarm to check if the radio works. If it |
| does not work, contact the Philips Consumer Care |
| Centre in your country. |
The radio does | The radio may be defective. Contact the Philips |
not work. | Consumer Care Centre in your country. |
The radio | Perhaps the broadcast signal is weak. Move the |
produces a | middle dial up or down to adjust the frequency and/ |
crackling sound. | or change the position of the antenna by moving it |
| around. Make sure you have unwound the antenna |
| completely. |
The alarm went off yesterday, but it did not go off today.
Perhaps you switched off the alarm function by setting the control lever to the top position.
Perhaps you set a sound level and/or light intensity level that is too low. Set a higher sound and/or light intensity level.
Perhaps there was a power failure that lasted more than approximately 15 minutes. In this case the appliance has remembered all settings except the clock time.The clock time therefore flashes on the display. Set the correct clock time.