H-P Products EG1400 owner manual General Operation, Attachments

General Operation

•The EG1400 is controlled by the on/off power control switch located on the hose handle. The headlight will operate when the EG1400 is turned on.

•To lower wand from the upright position, simply press on the handle release pedal.

•The powerhead has a pile height pedal Fig. D

for various carpet heights. (Fig. D) Select a pile height setting by pressing the small pedal on the rear of the EG1400. Use the extra low setting for short napped carpets and the high setting for plush carpets.

CAUTION: Do NOT leave the EG1400 running in one spot in the upright position for any length of time. Damage to carpet may occur.

Attachments

Using attachments on the hose handle:		Fig. E
1.	Press handle quick release button, then pull up on
	handle. (Fig. E) NOTE: if the EG1400 is
	attached, turn the powerhead off before removing
	handle from wands.
2.	Slide attachments firmly on hose handle as needed.
	In some cases, the button may need to be
	depressed to allow the attachment to slide up
	higher where it can seal on the metal tube.
Using attachments on wands:		Fig. F
1.	To remove the wands from the EG1400, lock wands
	in straight-up position. (Fig. F)
2.	Press wand quick release pedal with foot and pull
	straight up out of the EG1400. (Fig. G) The plug

and cord do not have to be removed to use	Fig. G
attachments on wands.

3.Put attachment on wands as needed. In some cases, the button may need to be depressed to allow the attachment to slide up higher where it can seal on the metal tube.