Pressure Relief Procedure

Follow this Pressure Relief Procedure when you stop spraying and before cleaning, checking, servicing, or transporting equipment.

1. Turn power switch OFF and unplug sprayer power cord.

WLD

2.Turn spray/prime valve to PRIME to relieve pressure.

35,0(

3.Hold metal part of gun firmly to side of a grounded metal

pail. Trigger gun.

TIAB

4. Engage trigger lock.

TIA

Pressure Relief Procedure

If you suspect the spray tip or hose is clogged or that pressure has not been fully relieved after following the steps above, VERY SLOWLY loosen tip guard retaining nut or hose end coupling to relieve pressure gradually, then loosen completely. Clear hose or tip obstruction.

Trigger Lock

Always engage the trigger lock when you stop spray- ing to prevent the gun from being triggered acciden- tally by hand or if dropped or bumped.

TIA

Installation

Do not modify the extension tube or roller frame or use parts not designed for this equipment.

Gasket (12) must be in place before installing frame

(1). If gasket is not in place there is a potential injection hazard which could result in serious injury.

Refer to your sprayer and spray gun instruction manu- als for safe operation of this frame.

1.Follow pressure relief procedure.

2.Prime pump (refer to your sprayer operation manual for this procedure).

3.Install roller frame.

311141A