ENGLISH | (Original instructions) |
BlADE SElECTION
your circular saw is designed for use with
NOTE: This saw is designed to cut wood and plastic. Do not use masonry or metal cutting blades. DO NOT use any abrasive wheels.
GENERAl CUTS
WARNING: To reduce the risk of injury, remove the battery, and follow all assembly, adjustment and set up instructions.
Make sure lower guard operates. Select the proper blade for the material to be cut.
•Measure and mark work for cutting.
•Support and secure work properly (See Safety Rules and Instructions).
•Use appropriate and required safety equipment (See Safety Rules).
•Secure and maintain work area (See Safety Rules).
•With battery inserted, make sure switch turns saw on and off.
SAWING
WARNING: To reduce the risk of serious personal injury, always hold the tool with both hands as illustrated in Figure G below.
•Let the blade run freely for a few seconds before starting the cut.
•Apply only a gentle pressure to the tool while performing the cut.
•Work with the shoe (5) pressed against the workpiece.
HINTS FOR OPTIMUM USE
• For best results use a blade with
• As some splintering along the line of cut on the top side of the workpiece cannot be avoided, cut on the side where splintering is acceptable.
• Where splintering is to be minimized, e.g. when cutting laminates, clamp a piece of plywood onto the top of the workpiece.
POCKET CUTTING (FIGURE G) | G |
WARNING: Never tie the blade guard in a raised position. Never move the saw backwards when pocket cutting. This may cause the unit to raise up off the work surface which could cause injury.
WARNING: To reduce the risk of serious personal injury, always hold the tool with both hands.
WARNING: laceration Hazard. As blade starts cutting the material, release the retracting lever immediately.
A pocket cut is one that is made in a floor, wall, or other flat surface.
•Tilt the saw forward and rest front of the shoe on material to be cut.
•Using the retracting lever (8), retract lower blade guard (7) to an upward position. Lower rear of shoe until blade teeth almost touch cutting line.
•Release the blade guard (its contact with the work will keep it in position to open freely as you start the cut). Remove hand from retracting lever and firmly grip the top of the power unit, as shown in Figure G.
Position your body and arm to allow you to resist kickback if it occurs.
•Make sure blade is not in contact with cutting surface before starting saw.
•Start the motor and gradually lower the saw until its shoe rests flat on the material to be cut. Advance saw along the cutting line until cut is completed.
•Release trigger and allow blade to stop completely before withdrawing the blade from the material.
•When starting each new cut, repeat as above.
10