10.Turn the Contact Tip counterclockwise and remove.
11.Lay the Torch Sheath out in a straight line so that the wire moves through it easily.
Warning: The following steps require applying power to the welder. Do not touch any- thing with the Torch Handle or an arc may be ignited.
12.Plug the Power Cord into its electrical outlet, press the Current Switch to Max., and turn the welder ON.
13.Lift the Torch Handle and continue pressing the Trigger until the wire feeds through two inches.
If the wire does not feed, view the Wire Feed Unit and see if the wire is being pushed. If it is not, turn the welder OFF and add more tension to the Wire Feed Adjusting Spring (36).
14.Turn the welder ON again and press the Trigger.
15.Once the wire is exposed, turn the welder OFF and unplug it.
16.Slide the Contact Tip over the wire and screw it into Torch Handle.
17.Replace the Nozzle and cut off any excess wire over two inches.
18.Secure the Cover.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 54878 | For technical questions, please call | Page |