Diamond manual CC1800XL Specifications

Specifications

Table 2: CC1800XL Specifications
Maximum Cutting Depth	4-5/8” with 14” blade
Maximum Cutting Depth	7-5/8” with 20” blade
Blade Shaft Diameter	1-1/4”
Blade Shaft RPM	2,600
Arbor Diameter	1” with single alignment pin
Blade Shaft Bearings	Self-aligning pillow block bearings
Blade Shaft Drive	Three or four 3VX V-belts
Blade Mounting	Right or left
Blade Raise/Lower	Screw feed
Blade Coolant	Dual multi-spray water tubes
Blade Guard Attachment	Slip-on up to 20”
Handlebars	Adjustable height and reversible
Transmission	Eaton model 6, or push model
Drive Speed	0-80 ft/min
Electric Start	GX620 Honda only
Fuel Capacity	Two gallons
Tachometer/Hour Meter	Standard on GX620 Honda
Quick Disconnect Blade Flanges	Standard
Frame Lift	Standard
Uncrated Dry Weight	280-415 lb (add 40 lb for crated weight)

Table 3: Engine Specifications

Manufacturer	Honda	Briggs Vanguard	Honda
Model	GX390	N/A	GX620
Fuel Type	Unleaded gasoline	Unleaded gasoline	Unleaded gasoline
Air Filter	Cyclone	Dual element	Snorkel type, dual element
Low Oil Alert	Standard	Standard	Standard
Note: Refer to the engine manual for additional information.

	Table 4: Electric Motor Specifications
Manufacturer		Baldor Electric
Phase/Voltage		1PH-230V, 3PH-230V, 3PH-460V, 3PH-575V

Note: Refer to the motor manual for additional motor specifications.

Table 5: Hydraulic Motor Specifications

Manufacturer	Danfoss Hydraulic
Displacement (cubic inches (CI)/revolution)	1.16CI, 1.55CI, 1.94CI

Note: Refer to the motor manufacturer for additional motor specifications.

10