Grizzly G0583 instruction manual Base and Supports, Components and Hardware Needed, Tools Needed

Base and Supports

Components and Hardware Needed:	QTY
Base	1
Casters	4
Round Support	1
Rectangle Support	2
Impeller/Separator	2
Handle	1
Hex Bolts 5⁄16"-18 x 1⁄2"	6
Hex Bolts M6-1.0 x 10	4
Acorn Nuts 5⁄16"-18	4
Flat Head Screws M6-1.0 x 10	2
Phlips Screw 10-24 x 3⁄8"	1
Flat Washers 5⁄16"-18	2
Tools Needed:
Wrench or Socket 12mm	1
#2 Phillips Screwdriver	1
To assemble the dust collector base:

1.Make sure the dust collector motor is unplugged!

2.Install the the casters with the four 5⁄16"-18 acorn nuts and washers. (see Figure 6).

Figure 6. Installing casters.

4.Place the round and rectangle supports on the base and install with six 5⁄16"-18 x 5⁄16" hex bolts (see Figure 7).

Figure 7. Impeller/separator supports.

5.Align the impeller/separator assembly with the supports, and install six 5⁄16"-18 x 1⁄2" hex bolts (see Figure 8).

6.Position the elbow as shown in Figure 8, and secure it in place with the #10-24 x 3⁄8" phlips head screw.

7.Position the handle as shown in Figure 8, and secure it in place with two M6-1 x 10 flat head screws.

Figure 8. Impeller/separator attached to base.

G0583 1 HP Canister Dust Collector -13-