3.Align the impeller/separator assembly with the supports, and secure it with (6) 5⁄16"-18 x 1⁄2" hex bolts (see Figure 8).
8.Install the handle onto the top of the canister and tighten the set screw against the flat of the shaft (Figure 10).
Elbow
x 6
Figure 8. Impeller/separator attached to base.
4.Position the elbow as shown in Figure 8, and secure it in place with the #10-24 x 3⁄8" flange screw.
5.Position the handle as shown in Figure 8, and secure it in place with two 5⁄16"-18 x 1" flat head screws.
6.Affix the narrow foam strip around the outside top rim of the collector, as shown in Figure 9.
Figure 9. Narrow foam strip affixed.
7.Trim the excess foam strip so the ends come together evenly, as shown in Figure 9.
-14-
Set Screw
Shaft Flat
Figure 10. Installing canister handle.
9.Place the canister on top of the collector.
10.Position the metal canister clamp around the bottom of the canister filter, so it will com- press around the foam strip (Figure 11), and latch the clamp closed.
Figure 11. Canister filter installed and secured.
Model G0583Z (Mfg. 3/09+)
