Electrical Connections, DC-650A and DC-650C

Electrical Connections

All electrical connections must be done by a qualified electrician. All adjustments or repairs must be

done with the dust collector disconnected from the power source, unplugged. Failure to comply may result in serious injury!

The DC-650 series dust collectors are rated at 115/230V, Prewired 115V. Use a plug and outlet rated at least 20 amps. The circuit for the machine should also be protected by at least a 20 amp circuit breaker or fuse. Keep in mind that a circuit being used by other machines, tools, lights, heaters, etc. at the same time will add to the electrical load. A dedicated circuit to the dust collector will give you the best results since dust collectors are generally used at the same time other tools are running.

Before hooking up to the power source, make sure that the switch is in the off position.

Turning the Machine On & Off

This machine is intended for indoor use only.

Before hooking up to the power source, make sure that the switch is in the off position.

DC-650A and DC-650C

Flip the Start/Stop toggle switch mounted next to the motor to the up position to start and down position to stop. This switch comes equipped with a removable key which can be removed for safety when not in use.

DC-650ARC and DC-650CRC

The DC-650ARC and DC-650CRC dust collectors can be controlled from the control panel mounted on the side of the motor (Figure 9) or from a remote control unit (Figure 10).

To start the dust collector, press the ON button. If the remote control unit (Figure 10) is used, aim it at the control panel (Figure 9). The machine will remain running until the OFF button is pressed. The digital readout will always display 00 while running.

Setting the Timer

Once the machine is running, press the TIME button to activate the timer. Each time the button is pressed and released, the run time is incremented on the digital display by one minute and can be set up to 99 minutes. If the TIME button is pressed and held, the time will scroll up to 99 minutes, then start again at 00. Release the button when the desired set time is

reached. The dust collector will run for the amount of time displayed on the digital display. If you scroll past 99 and release the button at 10, for example, the machine will run for ten minutes, not 110 minutes.

If the OFF button is pressed while machine is running with the timer engaged, the machine turns off and the timer is disengaged, i.e., when the machine is restarted, the timer must be reset.

Figure 9

Figure 10