Jet Tools DC-650C Filter Bag Installation DC-650A/ARC, Collector Bag Installation DC-650A/ARC

Page 9

Filter Bag Installation – DC-650A/ARC

1.Thread an M6 hex nut onto the filter bag support rod, followed by an M6 flat washer and M6 lock washer (A, Fig. 5). Thread the support rod (B, Fig.

5)into the motor/fan housing and tighten nut against the housing.

2.Place the retaining strap (C, Fig. 5) through the loops on the filter bag and hang the filter bag from the hook.

3.Secure bag to housing with retaining strap.

Note: The retainer strap should be tight enough to provide a good seal.

Figure 5

Collector Bag Installation – DC-650A/ARC

1.Insert the snap ring of collector bag into the bottom of housing at an angle, see Figure 6.

2.Pull down on the ring and bag to make sure it “seats” in the housing.

After completing the filter bag and collector bag installation, proceed to Electrical Connections.

Figure 6

9

Image 9
Contents Dust Collector More Information WMH Tool Group Warranty Warranty and ServiceTable of Contents Page Page Specifications IntroductionDC-650 Series Dust Collector Unpacking Contents of the Shipping CartonMotor Housing and Support Canister AssemblyBase Assembly Mounting the Support Canister to BaseCollector Bag Installation DC-650A/ARC Filter Bag Installation DC-650A/ARCCollector Bag Installation DC-650C/CRC Canister Installation DC-650C/CRCElectrical Connections Setting the TimerTurning the Machine On & Off DC-650A and DC-650CMaintenance Replacement Parts Parts ListParts TS-1540071 Parts Breakdown Remote Control Breakdown for DC-650ARC/CRC DC-650A/C Models Wiring DiagramsDC-650ARC/CRC Models Page WMH Tool Group