Maintenance

Never perform maintenance on this machine before turning switch off and removing plug from power source.

Failure to comply may cause serious injury!

Cleaning the Filter Bag – DC-650A/ARC

Wearing a particle mask/respirator for protection against fine dust particles during cleaning is highly recommended.

During first use and after cleaning, the filter bag may allow some dust to escape. This is normal and will stop after a short period of time.

Clean both the filter and collector bags frequently to keep the collector's performance at its optimum.

Wearing a particle mask/respirator for protection against fine dust particles during cleaning is highly recommended.

To clean:

1.Disconnect the machine from the power source.

2.Unhook the filter bag from the hanger and shake the bag so that the majority of the dust falls into the collector bag.

3.Loosen the retaining strap, and remove the filter bag from the housing.

4.Turn the bag inside out and clean.

5.Turn the bag outside in and re-attach to the housing using the retainer strap to secure.

Removing the Collector Bag –

DC-650A/ARC

Wearing a particle mask/respirator for protection against fine dust particles during cleaning is highly recommended.

1.Disconnect the machine from the power source.

2.Remove the collector bag by pushing the ring of the collector bag upwards and pulling the bag out at an angle.

3.Empty the contents into an appropriate container.

4.Turn the bag inside out and clean.

5.Turn the bag outside in and insert into the housing.

To reduce the risk of injury from moving parts, always keep the inlet connected to the flexible hose. Failure to comply may result in serious injury!

Cleaning the Filter – DC-650C/CRC

Clean both the filter and collector bag frequently to keep the collector's performance at its optimum.

To clean the filter turn the handle a couple rotations so the dust falls into the collector bag.

Removing the Collector Bag –

DC-650C/CRC

Wearing a particle mask or respirator for protection against fine dust particles during cleaning is highly recommended.

1.Disconnect the machine from the power source.

2.Remove the collector bag by pushing the ring of the collector bag upwards at an angle and pulling the bag and snap ring out.

3.Empty the contents into an appropriate container.

Motor

Make frequent inspections of the motor fan and blow out (with low pressure air hose) or vacuum any accumulation of foreign material in order to maintain normal motor ventilation.

Connecting the Dust Collector to a Machine

Use the proper type hose to connect the dust collector to the machine being operated. Dryer vent hose is not acceptable for this purpose. Contact your nearest JET distributor for the full line of JET Dust Collector Hoses and Accessories. Customize your installation and obtain maximum performance with JET's dust hoods, hoses, clamps, fittings, and blast gates.

Grounding the Dust Collection System

The dust collection system includes the dust collector and the hose, or ductwork you use to connect the tools. The dust collector is grounded though the ground wire in the cord. The hose or ductwork you use to connect the tool to the dust collector must also be grounded. To assist in grounding your system you can purchase the JET “Dust Collector Grounding Kit” stock # JW1053 through JET Distributors.