User checklist

If your cleaner is not working properly run through the following checklist.

1.Is there a working electricity supply to the cleaner? Check with another electrical product.

2.Is the dust container full or choked with fine dust? To empty the dust container, see instructions on P7.

3.Is the hose blocked?

To clear a blockage, see instructions on P8.

4.Is there a blockage in the cleaner base?

To clear a blockage, see the instruction on P8.

5.Are the filters blocked?

To clean filters, see the instruction on P7.

6.Is the nozzle height set correctly?

To set the carpet height selector, see the instruction on p4.

7.Are the brushes rotating correctly?

To check the brushes, see the instructions on p8.

8.Has the cleaner overheated?

If so, it will take about 30 minutes to reset.

If there is any doubt, call the Hoover customer Helpline 08444 995 599 for advice. They may be able to assist you over the telephone.

WARNING

A thermal cut out switches off the cleaner to prevent overheating if it is used when full or there is a blockage or dirty filters. If this should happen switch off, unplug and correct the fault.

It will take approximately 30 minutes for the cut out to automatically reset.

IMPORTANT

DO NOT RUN OVER THE POWER SUPPLY CORD AS THIS COULD DAMAGE THE SUPPLY CORD INSULATION.

- 10 -

48003559 Turbopower IM UK.indd 10

5/15/2012 9:56:29 AM