CHANGING THE BELT OR BRUSHES
If your cleaner is not picking up efficiently, the belt or brushes (or both) may need replacing, but first please make sure you have:
CLEARING A BLOCKAGE
IMPORTANT: Switch the cleaner off and remove the plug from the electricity supply
•Emptied the dust container
•Cleaned the filters
•Checked for blockages
1Turn the cleaner over and remove 5 retaining screws attaching the brush guard to the base.
IMPORTANT: Switch the cleaner off and remove the plug from the electricity supply before dismantling cleaner
4Hold the brush assembly and stretch the belt until the brush can be slotted back into the cleaner housing.
before dismantling cleaner
If cleaning tools were in use check the cleaning tool and the removable handle.
Check the hose by removing it from the cleaner, stretching it to full length .
2 | Remove the brush guard | 5 | Rotate the brush to ensure movement of the belt. |
|
|
3 | Remove brush assembly and check for wear | 6 Refit the brush guard with 5 retaining screws. |
| on the belt. Loop the new belt around the motor |
|
and brush channel.
* Certain models only. | - 8 - |
Turn the cleaner over and rotate the brushes until they are free to rotate.
Check for a blockage in the hose socket. Use a flexible rod to remove any obstruction.
Removing a blockage from the pet hair & allergen remover.
Open the nozzle at each side, lift cover and remove the blockage.
*Certain models only.
48003559 Turbopower IM UK.indd 8
5/15/2012 9:56:29 AM