Canister System Assembly
(17mm wrench required)
1.Place the snap ring over the top of the plastic collector bag, and fold over the bag approximately three inches (Figure 8).
Figure 8
2.Insert the snap ring of the collector bag into the bottom of the housing at an angle (Figure 9).
3.Pull down on the snap ring to make sure it “seats” on the inner lip of the housing.
Note: Make sure the snap ring “snaps” into place in the housing, and also that the plastic bag hangs down approximately 3 inches so that there are no air leaks.
4.Remove the handle (Figure 10) from inside the canister filter. Mount the handle onto the canister filter with two M10 hex nuts (A), two M10 flat washers (B), and an M10 lock washer (C). Arrange these fasteners according to Figure 10. Tighten with a 17mm wrench.
5.Place the canister on top of the housing, and push down to ensure the canister is seated on the housing.
6.Insert and tighten the four knobs into the threaded holes on the canister (Figure 10).
Note: The Powermatic® label on the front of the canister should have a negligible effect upon air flow. However, if zero effect is desired, the label can always be peeled off.
Figure 9
Figure 10
11