Powermatic PM1900TX manual Unpacking, Contents of Shipping Carton

Unpacking

Remove all contents from the shipping carton and check against the Contents of Shipping Carton below to verify that all items have been received.

Report any damage to your distributor.

Do not discard any shipping material until after the dust collector has been assembled and is running properly.

You will also require either the Filter Bag System or Canister Filter System. These items are packaged separately and are not listed here.

Contents of Shipping Carton

Refer to Figure 3 to identify items K–Z.

KBase (1)

LBase Extension (2)

MCaster (4)

NMotor/Impeller Assembly (1)

OInlet Guard (1)

PInlet Port w/ Cap (1)

QLower Gasket (1)

RConnector Tube (1)

SControl Box (1)

TUpper Gasket (2)

ULeft Housing (1)

VRight Housing (1)

WSupport Bar (2)

XHandle (2)

YPlate (2)

ZSocket Head Cap Screw, M8x12 (4)

--Remote Control w/ batteries (single phase machine only) (not shown)

--Owner's Manual (not shown)

--Warranty Card (not shown)

Main Hardware Bag contents (Figure 1):

A – M8 x 20 Hex Cap Screws (34)*

B – M6 x 12 Pan Head Flange Screws (8)* C – 3/16” x 1/2” Pan Head Flange Screw (1)* D – M8 Flat Washers (60)*

E – M10 Flat Washers (6)* F – M8 Hex Nuts (30)*

G – M8 Lock Washers (4)*

H – 3/8" Hex Nuts (4) – on casters

J – M10 Lock Washers (4) – on casters

Cone Assembly and Hardware (Figure 2):

AA– Support Bracket

BB– Cone

CC– M8 x 16 Hex Cap Screws (2)

DD– M8 Flat Washers (2)

EE– M8 Hex Nuts (2)

FF– M 6 x 12 Hex Cap Screws (8)

GG– M6 Hex Nuts (8)

Figure 1: Main Hardware Bag contents

*A through G comprise PM1900-BMHP Base Machine Hardware Package

Figure 2: Cone Assembly and Hardware

CCthrough GG comprise DC1100-HP2 Cone Assembly Hardware Package

Tools Required for Assembly

13mm Wrenches or Sockets 14mm Wrench

#2 Cross Point Screw Driver 6mm hex (“Allen”) wrench

7